Shear bond strengths of different adhesive systems to white mineral trioxide aggregate.

Bayrak Ş., Tunç E. S., Saroğlu I., Eğilmez T.

Dental materials journal, vol.28, pp.62-7, 2009 (SCI-Expanded) identifier identifier identifier

  • Publication Type: Article / Article
  • Volume: 28
  • Publication Date: 2009
  • Doi Number: 10.4012/dmj.28.62
  • Journal Name: Dental materials journal
  • Journal Indexes: Science Citation Index Expanded (SCI-EXPANDED), Scopus
  • Page Numbers: pp.62-7
  • Eskisehir Osmangazi University Affiliated: No


This study was conducted to compare the shear bond strengths of different adhesive systems to White Mineral Trioxide Aggregate (WMTA). To this end, 40 cylindrical acrylic blocks with a hole in the middle measuring 4 mm diameter X 2 mm height were prepared. The hole was filled with WMTA, and the specimens were allocated into four groups: Group 1 Prime & Bond NT; Group 2 - AdheSE; Group 3 - Xeno III; and Group 4 - Adper Prompt L-Pop. In each group, a different adhesive system and a compomer (Dyract AP) were applied over WMTA. Shear bond strengths were measured using a universal testing machine, and then the data were subjected to one-way ANOVA and Scheffe's post hoc test (p < 0.05). Significantly lowest shear bond strength value was obtained with Adper Prompt L-Pop, whereas Prime & Bond NT revealed higher shear bond strength than the others (p < 0.05). In conclusion, an etch-and-rinse adhesive system which exhibited significantly higher shear bond strength than self-etch adhesive systems - could be a preferred choice when placing compomer materials upon WMTA.